Slitter line. The F-DI 8 x 24VDC HF on our ET 200SP station died Friday, DIAG solid red, channels dead. I ordered the same order number, fitted it this morning in the same slot, and swapped the BaseUnit while I was in there because the old one had a broken clip.

Station runs now, but the new module just sits passivated with DIAG flashing red. Buffer says something like "PROFIsafe: F-destination address does not match" and the safety program's holding the door channels at 0. I power cycled the station twice and downloaded the safety program again from the laptop, TIA V16, and it's still doing it.

Did they send me the wrong module? Photo of the old and new labels attached, they read the same to me. Could anyone point me in the right direction here?