Last seen: Sep 21, 2026
Pulled the right station. NC wire is on a block in the rear position of the stack, the front position has the NO and a spare. Left station has the NC ...
Tree green means backplane green. Nothing else. Same lesson we learned.
Yep. Had the exact same on a palletizer here. The card holds a copy of the project and On Power Up means every boot loads that copy over whatever was ...
We run 500 on the DCS blocks for mushroom heads on our GuardLogix side. Different box, same idea. Is a slammed door really meant to get two contacts a...
Checked all eleven. Every rack's on 2 ms, the drives too. The contractor left it that way I guess, we've never touched any of it and nobody here has o...
Meggered at 6am before anyone touched it: 0.4 megohm. After two hours running: 60 megohm. Opened the junction box. Gasket flat as paper, no drain plu...
COM on +24 is the whole thing. That makes it a sourcing input, not a sinking one, different animal. With COM at +24 the module pushes current out of t...
Studio 5000 v33, EN2T firmware 11 point something. Web page says about 23000 packets per second with the line running. During start-up I saw 26000 and...
So the diode direction matters. Put it in backwards and it's a dead short across the coil the moment the output comes on?
Ok, what voltage on the megger? We have a 1000V one in the shop, not sure that's the right setting for a motor. And yes, damp mornings. We're next to ...
Watched them online on the 1734-IB8S. Left button slow: NO goes on, NC goes off, basically together. Right button slow: NO goes on straight away, NC g...
We had a Plus 6 lose time and that one was the battery, but it went back to 2007 on every power cycle, it didn't drift. Yours keeps time through a pow...
Same thing on the old press. We had a profibus run that started doing exactly this after an extension, and it turned out the electricians had used a d...
Rewrote station 3 over the weekend stop. Step is a DINT, 15 transition rungs top to bottom in reverse, one EQU rung per output. 4000 cycles Monday and...